(1) x Complete set of 20.5" Racing Stripes [Total Width 20.5"]
(1) x Front Skirt Stripe
(1) x Front Bumper Stripe
(1) x Hood Stripe
(1) x Roof Stripe
(1) x Trunk Stripe
(1) x Spoiler Stripe
(1) x Rear Bumper Stripe
(1) x Squeegee with Felt
Premium Cast Vinyl Material (Oracal #651)
This kit is pre-cut in different sections of the car and can be easily adjusted to your personal preference.
You may choose to run the stripes all the way to the bottom of the car or stop sooner. This kit's modular design allows you to do this without any extra effort.
These kits are designed with pre-cut sections for each body panel.
Minor trimming of excess material may be required. All sections come with excess vinyl to account for vehicle body curves and edges.
What do I need?:
Spray Bottle w/ Dish Soap and Water Mixture
Pair of scissors
Sharp Razer Blade/Knife
How to Install your decal:
This kit requires a moderate amount of knowledge in regards to installing decals. This is very important if using the dry method which is the preferred method of professionals. However, that method is much harder to perfect.
Please follow the instructions provided as Fusion Decals will not be responsible for improper installation. We recommend for DIY customers to use the wet method as you can slide the material around during the installation.
Series 651 Features:
This vinyl is for Permanent use, however with mild heat and technique this vinyl can be removed fairly easily if not overheated. (Goo-gone recommended)
Calendared 2.5-mil PVC
Gloss finish is thermal-transfer compatible
Solvent acrylic permanent adhesive
Designed for short-term and medium-term outdoor applications such as corrugated signs, economy banners and flat- surface applications
100% splice-free rolls, every time
6 year outdoor durability
CANthe red gloss stripes come 10 inch and will there be enough to make 2 strips for the Length of the car bumber to bumper?
We would need to redesign the kit from scratch if you needed 10 inch. The reason is that the 10 inch will not be wide enough to go around the emblems and plate as with the cutouts for the 20 inch. Also all of our kits come with sections to completly wrap around the bumpers with a bit of extra length that would just need to be trimmed once installed.